Collectors of minting errors occasionally come across terms that
have fallen into disuse.
One such moniker is the “folded planchet error.” It has largely
been supplanted by the label “foldover strike.” A foldover strike is a
coin that is struck on-edge and folded over in the process.
A rather unusual example is shown here in a Lincoln cent struck
some time in the 1980s. It’s an in-collar foldover strike. When it was
struck, the planchet was standing up in the far northwest quadrant of
the striking chamber. The side of the planchet that faced toward the
interior of the striking chamber did so toward the southeast. It was
bent perfectly in half by the force of the strike, with the bend also
occurring in the southeast direction. The edge of the folded-over flap
can be seen just inside the design rim on the obverse face.
Given the precise three-dimensional positioning required to
generate an in-collar foldover strike, it’s not surprising that I’ve
only come across three examples in my years of collecting.
Less precise terminology
General abandonment of the term “folded planchet error” may be due
to its being a less precise term than “foldover strike.” But it’s
fortunate in another sense. Coinage dies are not the only machine
parts that can fold a planchet in two.
Folding can also occur before the strike. Pre-strike damage that
folds over part of a blank or planchet is rare, but it’s important to
recognize its existence and the potential for misidentification.
I’ve chosen to illustrate this category of damage with a 1964-D
Jefferson 5-cent coin. Part of the planchet was torn up and folded
over onto what would ultimately become the obverse face. The flap —
free at both ends but connected in the middle — was struck into the planchet.
Its hatchet-shaped outline is marked by a thin fissure. Any
struck-in or rolled-in piece of metal will usually be demarcated by a
The coin weighs 4.91 grams —slightly underweight (it should weigh
5 grams) but still within the normal range of variation for this denomination.
5-cent coin not unique
I have no idea what piece of machinery generated this damage, but
it’s not unique. I’ve seen at least one other 5-cent coin with the
same kind of struck-in flap. Neither of these coins was correctly
diagnosed and described. While neither was pegged as a foldover strike
(or folded planchet error), they were also not correctly identified as
examples of pre-strike damage. Coin dealers and grading services are
most likely to identify such errors as “defective planchets,”
“straight clips” or “ragged clips.”
Whatever piece of machinery is responsible for this damage, it
more often tears off the flap completely. This is what happened to a
second 1964-D Jefferson 5-cent coin illustrated here.
It was sold to me years ago as an off-center strike on a straight
clip planchet by a prominent error dealer. The ends of the straight
margin are beveled on both faces and taper to a sharp edge.
Other denominations known
I’ve encountered this more severe type of pre-strike damage on
denominations from cent to quarter dollar. The most recent example is
a 1999-P Roosevelt dime that can be found on the Combined
Organizations of Numismatic Error Collectors of America website
Based on the evidence provided by the different pre-strike
planchet damage coins encountered, evidently, the minting mechanism
responsible for this planchet damage has been in use for decades.
Coin World’s Collectors’ Clearinghouse department does not accept
coins or other items for examination without prior permission from
News Editor William T. Gibbs. Materials sent to Clearinghouse without
prior permission will be returned unexamined. Please address all
Clearinghouse inquiries to email@example.com or to
(800) 673-8311, Ext. 172.